Week 10 - Changing the LCD module and Power Supply.

-

         After the new 5V AC to DC power supply and LCD module arrived, I disconnected the damaged LCD and plugged in the new LCD module. The pins connection is just the same as the previous LCD module. Then I connect the 5V power supply to the power jack of the Arduino Uno board and turn on the supply. The LCD worked and I waited for the GSM to establish a connection to test the project. The project runs smoothly as intended. In conclusion, the 5V power supply is sufficient for the project to run.

Comments

Post a Comment

Popular posts from this blog

Week 11 - Designing and assembling the door for the project.

-
Image
                For this week, I designed the door structure for the project. The design of the door prototype is done by hand. The size of the door is smaller compared to normal doors as the door is only a prototype. The measurements of the components are taken and written in a note. The design and measurements are then taken to a local carpenter to cut the planks and woods to assemble the door. 2 door hinges are used so that the door can be opened and closed. A door handle is screwed to the door so that users can grab the handle to open the door. All components are screwed inside the door securely so that they do not move around and get damaged. 
Read more

Week 16 - FYP Slides and Presentation Preparation.

-
Image
           For this week, I submitted the draft of the technical report and final year project report to Sir Izwan. The purpose of submitting the report is so that the supervisors can help the student check their report format and contents, and to help check the plagiarism percentage before submitting the real report. The percentage should not exceed 30% as told during the final year project briefing. The draft report of this project scored 14% after doing the plagiarism check.          I also did the presentation slides for the final year project presentation. The content of the slides was taken from the final year project report. The slides were arranged following the guideline given by the final year project coordinator. 
Read more